installation Guide

installation instructions

Clean your display carefully with the enclosed wet cloth.
Thoroughly dry and polish your display with the included smartect microfibre cloth.
Peel off the anti-dust sticker at one corner and stick it on the display. Repeat this process several times until there is no speck of dust left on the display.
Peel off the adhesive backing. Be careful not to contaminate the adhesive surface.
Position the protective glass precisely over the display. If necessary, use the cut-outs for speakers, camera, etc. as a guide. Press the protective glass lightly onto your display. The glass sucks itself through the coated surface.

Clean your display carefully with the included wet wipe.
Dry and polish your display thoroughly with the included smartect microfiber cloth.
Peel off the anti-dust sticker at one corner and stick it onto the display. Repeat this process several times until there is no more dust on the display.
Position the positioning aid on the smartphone.
Peel off the protective film. Make sure that the adhesive surface does not become contaminated.
Position the protective glass precisely over the display. The coated surface allows the glass to stick to the screen by itself.

Place the smartphone on the anti-slip mat.
Clean your display carefully with the included wet wipe.
Dry and polish your display thoroughly with the included smartect microfiber cloth.
Insert the alignment tool into the charging port.
Use the anti-dust sticker to remove dust from the display.
Align the film with the 3 holes at mark 2 on the alignment tool, paying careful attention to the center alignment of the entire film.
Now press the dark area in the middle of the film onto the display.
Lift the upper half of the film (mark 1) at a 120° angle and slide the film upwards from the middle using the slider so that the protective paper comes off.
Remove the alignment tool.
Now lift the lower half of the film (marking 2) at a 120° angle and slide the film downwards from the middle with the slider so that the protective paper comes off
Go over the entire film again with the slider to remove any remaining bubbles. Peel off the protective film at mark 2.
Use your thumb to press the edges of the film firmly.
Now clean the film again with the microfiber cloth.